Protectli router11/11/2023 Note2: If you have a Hub4 and your own router is NOT 192.168.0.1 then it’s possible that you can still access the VM hub on 192.168.0. Note1: this only needs doing once for each new router or when VM changes your WAN IP address. Thanks to its fanless design, the Vault is com. On a Hub5 use port 4.Ħ) You should now be able to access the internet and the hub will now be on 192.168.100.1 The Protectli Vault is a small form factor PC for use as a firewall micro appliance / mini PC / router. ![]() Best done from a wired connection.Ģ) Turn off the hub and disconnect any Ethernet cablesģ) Fully initialise your own router or mesh master unit and make sure the WAN port is set to DHCP (for some routers or mesh this may have to be done in router mode before entering modem mode)Ĥ) Connect your router or mesh master unit to the VM hub with an Ethernet cable, Cat5e or Cat6, any higher specification is a waste of money. On the Hub3 the bottom LED will change to magenta, on a Hub4 the LED band will be green, on a Hub5 the LED will be green. Compact: only 6.1 x 5 x 2. Since there are no fans, the case acts as the head sink so the Vault is 100 silent. ![]() This Vault features 6 Ethernet ports, as well as AES-NI. ![]() 1) Access your hub on 192.168.0.1, sign on and put it into modem mode. The Protectli Vault comes in different variations depending on your needs: Up to 6 Ports, 64GB RAM, 4.5TB SSD storage and more. Protectli Vault - 6 Port More ports, more power: The 6 Port Vault is best for use in medium to large teams/companies.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |